Hello, I am trying to control the amcc glacier (evkit460gt) eval board with a BDI3000, using the config file from ftp://78.31.64.234/bdigdb/config/powerpc/ppc4xx/ppc440/evkit460gt.cfg (modulo my local IP/tftp configuration).
The problem is that the board fails to run under the BDI control, and runs just fine without it. When looking closer I see that the bdi resets the board properly and takes it all the way to the point where the TLBs are set and the rfi instruction is executed to jump out of the original 4k window. At this point a TLB exception is thrown, that is it loos like TLB programming 'did not take' while under BDI control. So, if I just reset the board and let it run, it keeps cycling through TLB error exception as no memory other than the top 4k bytes is accessible. Again, it works just fine without the BDI. Any hints and suggestions will be highly appreciated, TIA, Vadim ------------------------------------------------------------------------- Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! Studies have shown that voting for your favorite open source project, along with a healthy diet, reduces your potential for chronic lameness and boredom. Vote Now at http://www.sourceforge.net/community/cca08 _______________________________________________ U-Boot-Users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/u-boot-users
