Hello,
thanks a lot.
Could you please take care that this will be fixed in the kernel code, too ?
Best regards
Manuel Sahm
Anatolij Gustschin schrieb:
Manuel Sahm wrote:
if I apply the patch with:
patch -p1 < patchat91.diff
some messages occur, is this correct ?
(Stripping trailing CRs from patch.)
patching file board/atmel/at91sam9260ek/at91sam9260ek.c
patch unexpectedly ends in middle of line
Hunk #1 succeeded at 183 with fuzz 2 (offset -5 lines).
it is very likely that these messages occur because the patch
was incorrectly saved from the email body. This patch applies
cleanly against top of our u-boot git tree.
The description is correct - PA23 and PA24 are connected to the TWI
EEPROM an the DevBoard at91sam9260ek.
The patch works well.
Here the signed-off line:
Signed-off-by: Manuel Sahm <[EMAIL PROTECTED]>
Thanks, I will repost the patch again.
Another problem is, that the same error is in the official kernel tree
in the file at91sam9260ek_devices.c ?!
Although the error is still in the kernel, a modification of the uboot
file at91sam9260ek.c is enough to get ethernet working ?
if the kernel resets Peripheral B pin configuration, then
ethernet will stop working, I think. This should be fixed in
the kernel code, too.
Best regards,
Anatolij
-------------------------------------------------------------------------
Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW!
Studies have shown that voting for your favorite open source project,
along with a healthy diet, reduces your potential for chronic lameness
and boredom. Vote Now at http://www.sourceforge.net/community/cca08
_______________________________________________
U-Boot-Users mailing list
U-Boot-Users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/u-boot-users
