Hi Wolfgang,
yes I do have CONFIG_AUTOBOOT_KEYED enabled. It's the PMC440 board:
include/configs/PMC440.h:
...
#define CONFIG_AUTOBOOT_KEYED 1
#define CONFIG_AUTOBOOT_PROMPT \
"Press SPACE to abort autoboot in %d seconds\n", bootdelay
#undef CONFIG_AUTOBOOT_DELAY_STR
#define CONFIG_AUTOBOOT_STOP_STR " "
...
Matthias
On Thursday 11 September 2008 22:55, Wolfgang Denk wrote:
> Dear Matthias Fuchs,
>
> In message <[EMAIL PROTECTED]> you wrote:
> >
> > I noticed some strange CTRL-C behavior in a BSP command.
> > When I run my bsp command interactively everything is fine.
> ...
> > But when I call this bsp command as bootcmd CTRL-C does not stop the while
> > loop. So CTRL-C
> > is not detected. Any idea?
>
> Do you happen to have CONFIG_AUTOBOOT_KEYED set in your board
> configuration?
>
> Best regards,
>
> Wolfgang Denk
>
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
