Hi Thomas, I'm still debugging the MUSB driver on my Blackfin board. I got a issue here: https://blackfin.uclinux.org/gf/project/u-boot/tracker/?action=TrackerItemEdit&tracker_id=153&tracker_item_id=4794
1. when the board power on and run 'usb start', the usb function is ok for usb storage usage. 2. then I tried 'usb stop'. and run 'usb start' again. usb device cannot be found. Is that OK on davinci or omap platform? Thanks -Bryan On Sun, Jan 4, 2009 at 12:10 PM, Thomas Abraham <[email protected]> wrote: > This patch series adds Mentor Graphics USB OTG host controller > driver support and MSC support for DM6446 (TI DaVinci) platform. > > - [PATCH v3 1/5] usb : musb : Adding host controller driver for Mentor USB > controller. > - [PATCH v3 2/5] usb : musb : Adding USB VBUS enable functionality for DM6446 > DVEVM. > - [PATCH v3 3/5] usb : musb : Adding DM6446 (TI DaVinci) platform specific > USB support. > - [PATCH v3 4/5] usb : musb : Enabling DM6446 (TI DaVinci) USB module power. > - [PATCH v3 5/5] usb : musb : Enabling USB MSC support for DM6446 (TI > DaVinci) platform. > > Note: This patch series depends on the following patch submitted by > Michael Trimarchi. > > - [U-Boot] [USB PATCH] USB change speed > > Changes since v2: > > - Addressed changes suggested by Dirk Behme > - Added register overlay structure to access mentor USB module registers > > Changes since v1: > > - Rebased to U-Boot USB next branch > - Removed high element from usb_device structure > > _______________________________________________ > U-Boot mailing list > [email protected] > http://lists.denx.de/mailman/listinfo/u-boot > _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
