Hi Everybody,
I am new to board bring up and I have a few queries.
We have a custom board with a PPC 460EX processor and a NAND flash. We
are using a BDI 3000 JTAG debug interface.
My problem is how to load the u-boot onto the NAND flash on the fresh
board, since the BDI does not support writing into
NAND flash. Also from the mailing lists I understand that it is
difficult to execute the u-boot by directly downloading to the
RAM and executing it.
Please guide me on how to approach this.
Thanx in advance.
Thanks & Regards
Afzal Nadirshah| Senior Engineer | MindTree Ltd. Phase - I, Global Village West
Campus, RVCE post, Mysore Road, Bangalore - 560059 |
Voice +91 80 26264100 Extn: 66759 / Fax +91 80 2671 4000 | email:
[email protected]<mailto:[email protected]>
|www.mindtree.com<http://www.mindtree.com/> |
________________________________
http://www.mindtree.com/email/disclaimer.html
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
