Rommel,
I am using your recently posted patch to boot my custom Virtex4 board with
XMD. Execution gets stuck in the NS16550_init() function. It gets stuck
at this line:
#if (!defined(CONFIG_SYS_NS16550_BROKEN_TEMT))
while (!(serial_in(&com_port->lsr) & UART_LSR_TEMT))
;
#endif
If I define CONFIG_SYS_NS16550_BROKEN_TEMT, it gets stuck in the while loop
in NS16550_putc:
while ((serial_in(&com_port->lsr) & UART_LSR_THRE) == 0)
;
serial_out(c, &com_port->thr);
>From the GDB output, I can see it is using the correct address for the the
serial port (0x84000000)
(gdb) target remote localhost:1234
Remote debugging using localhost:1234
NS16550_putc (com_port=0x84000000, c=13 '\r') at ns16550.c:91
91 while ((serial_in(&com_port->lsr) & UART_LSR_THRE) == 0)
(gdb)
In your opinion, is your patch providing everything that I need to boot
with XMD? Can you suggest what I might be doing wrong?
Thanks for any insight you may have,
Frank
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
