Dear renjith kumar, In message <a8474bd70903181921p383be5aatcf36a1727f8f3...@mail.gmail.com> you wrote: > > I was wondering , is there any Discussion or document that describe the way > how I can Add a new device to u-Boot.
There is the README, and there is the U-Boot home page, especially http://www.denx.de/wiki/U-Boot/Patches > For example , I have two sequoa based, Custom design. > > 1) . I have an FPGA Device at the EBC port of EPx in the second design. > > 2) . In a second case, I have an FPGA Device as the PCI card for ppc440EPx. > (May be ok with Normal PCI Detection, but How to drive it ? Any standard > approach). If this is the only difference, then eventually a single new board configuration may be sufficient. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de If the odds are a million to one against something occuring, chances are 50-50 it will. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
