Hi Hector, On Tue, Feb 26, 2013 at 9:19 AM, Hector Palacios <[email protected]> wrote: > Greetings, > > I'm porting a custom platform based on mx28evk to latest U-Boot. > I modified the iomux.c for my platform (different DUART pins) and made some > changes to mxs_adjust_memory_params() to accommodate to my DRAM chip. > > I built the u-boot.sb. The platform however does not boot either from USB or > from MMC.
Please try booting from NAND as per the instructions from: doc/README.mx28_common > When loaded through USB, sb_loader complains with the messages at [1]. > I fear the CPU resets before even executing the SPL code, but how could I > tell? Is there a way to check if the CPU reaches this code at all? > I don't see any ROM error codes either and the CPU seems to reset (when the > USB recovery mode fails, the target defaults to boot from flash my old v2009 > U-Boot). > Is there any other init stuff (linker scripts or something) I should take > care of that's preventing sb_loader to fully load the image? Do you have a diff of your bootlets changes from your FSL U-boot? Then make sure these changes are incorporated into U-boot. Or maybe post RFC patches for your board addition into the mailing list, so that people can comment. _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
