With CONFIG_USE_IRQ and DEBUG macro defined,
display_banner function printed stack address
for IRQ and FIQ.
Global variables IRQ_STACK_START and FIQ_STACK_START
are set in interrupt_init function.
The function display_banner is called from board_init_f,
while interrupt_init is called from board_init_r.
So, display_banner always resulted in just printing initial
values of IRQ_STACK_START and FIQ_STACK_START as follows:
IRQ Stack: 0badc0de
FIQ Stack: 0badc0de
It is almost meaningless information because 0x0badc0de
is a hard-coded value in arch/arm/cpu/$(CPU)/start.S.
This commit moves the stack info display code
after interrupt_init call.
Signed-off-by: Masahiro Yamada <yamad...@jp.panasonic.com>
---
arch/arm/lib/board.c | 10 ++++++----
1 file changed, 6 insertions(+), 4 deletions(-)
diff --git a/arch/arm/lib/board.c b/arch/arm/lib/board.c
index 09ab4ad..34a394e 100644
--- a/arch/arm/lib/board.c
+++ b/arch/arm/lib/board.c
@@ -126,10 +126,6 @@ static int display_banner(void)
#ifdef CONFIG_MODEM_SUPPORT
debug("Modem Support enabled\n");
#endif
-#ifdef CONFIG_USE_IRQ
- debug("IRQ Stack: %08lx\n", IRQ_STACK_START);
- debug("FIQ Stack: %08lx\n", FIQ_STACK_START);
-#endif
return (0);
}
@@ -650,6 +646,12 @@ void board_init_r(gd_t *id, ulong dest_addr)
/* set up exceptions */
interrupt_init();
+
+#ifdef CONFIG_USE_IRQ
+ debug("IRQ Stack: %08lx\n", IRQ_STACK_START);
+ debug("FIQ Stack: %08lx\n", FIQ_STACK_START);
+#endif
+
/* enable exceptions */
enable_interrupts();
--
1.7.9.5
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
