Dear Scott Wood, > On 07/02/2013 10:11:55 AM, Marek Vasut wrote: > > The driver triggered a BUG() in nand_base.c:3214/nand_scan_tail() > > because the ecc.strength was incorrectly set in case of NAND_ECC_HW > > instead of NAND_ECC_HW_SYNDROME ECC mode. > > > > Signed-off-by: Marek Vasut <[email protected]> > > Cc: Benoît Thébaudeau <[email protected]> > > Cc: Fabio Estevam <[email protected]> > > Cc: Scott Wood <[email protected]> > > --- > > > > drivers/mtd/nand/mxc_nand.c | 7 ++----- > > 1 file changed, 2 insertions(+), 5 deletions(-) > > > > diff --git a/drivers/mtd/nand/mxc_nand.c b/drivers/mtd/nand/mxc_nand.c > > index ac435f2..08c7b8b 100644 > > --- a/drivers/mtd/nand/mxc_nand.c > > +++ b/drivers/mtd/nand/mxc_nand.c > > @@ -1238,15 +1238,12 @@ int board_nand_init(struct nand_chip *this) > > > > this->ecc.write_oob = mxc_nand_write_oob_syndrome; > > this->ecc.bytes = 9; > > this->ecc.prepad = 7; > > > > - } else { > > - this->ecc.mode = NAND_ECC_HW; > > - } > > - > > - if (this->ecc.mode == NAND_ECC_HW) { > > > > if (is_mxc_nfc_1()) > > > > this->ecc.strength = 1; > > > > else > > > > this->ecc.strength = 4; > > > > + } else { > > + this->ecc.mode = NAND_ECC_HW; > > > > } > > Where does ecc.strength now get set for the non-SYNDROME case?
Gone ;-) The strength only needs to be set for the SYNDROME case according to the code in nand_base.c . Best regards, Marek Vasut _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
