On Fri, Jun 14, 2013 at 10:54:59AM +0200, Stefan Roese wrote: > SPL already has GD set to the correct location (in s_init), we mustn't > move it around now since some data (clocks etc) is already present. > > This error was detected on the SPL port for the Compulab CM-T35 board > (OMAP3530). > > Signed-off-by: Stefan Roese <[email protected]> > Cc: Tom Rini <[email protected]> > Cc: Albert ARIBAUD <[email protected]>
While we have a problem here, it's not a problem that's visible on current SPL using platforms, just the CM-T35, yes? I just gave my beagleboard (classic and xM) a spin and they're OK. I've got a few more platforms I can dig out if needed, but I'm inclined to hold this until after v2013.07 and we can take one of the paths Albert outlined (change s_init to system_init, add to the function table, call that way). Does that work or have I underestimated the impact of this issue? Thanks! -- Tom
signature.asc
Description: Digital signature
_______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
