Hi Andreas,
On 9/4/2013 6:23 PM, Andreas Bießmann wrote:
Hi Bo,
On 08/28/2013 04:54 PM, Bo Shen wrote:
Add possible to use software BCH ECC for atmel nand driver
Signed-off-by: Bo Shen <voice.s...@gmail.com>
---
drivers/mtd/nand/atmel_nand.c | 4 ++++
1 file changed, 4 insertions(+)
diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index 96aca00..52efbee 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c
@@ -1177,7 +1177,11 @@ int atmel_nand_chip_init(int devnum, ulong base_addr)
mtd->priv = nand;
nand->IO_ADDR_R = nand->IO_ADDR_W = (void __iomem *)base_addr;
+#ifdef CONFIG_NAND_ECC_BCH
+ nand->ecc.mode = NAND_ECC_SOFT_BCH;
+#else
nand->ecc.mode = NAND_ECC_SOFT;
+#endif
I don't think this is enough for sw supported bch. Where do you feed the
libbch?
Yes, we need libbch.
If we really want to enable software BCH support. It also need add
following two options in board configuration file.
---8>---
#define CONFIG_NAND_ECC_BCH
#define CONFIG_BCH
---<8---
So, this patch give us option to enable software BCH.
Best regards
Andreas Bießmann
Best Regards,
Bo Shen
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
