On 24/08/2013 16:51, Elie De Brauwer wrote: > On a board with an i.mx28 and a Micron MT29F4G08ABAEAH4, Linux says: > > NAND device: Manufacturer ID: 0x2c, Chip ID: 0xdc (Micron MT29F4G08ABAEAH4), > 512MiB, page size: 4096, OOB size: 224) the ECC strength is 16. > > root@(none):/sys/devices/virtual/mtd/mtd0# for i in ecc_strength oobsize > subpagesize; do echo $i = `cat $i`; done > ecc_strength = 16 > oobsize = 224 > subpagesize = 4096 > > The ECC strength was not properly discovered by U-Boot causing the data > written by Linux to return an -74 (EBADMSG) when read from U-Boot. This > patch fixes mxs_nand_get_ecc_strength() to function in case of a NAND > flash with page_data_size = 4096 and page_oob_size= 224. > > Signed-off-by: Elie De Brauwer <eliedebrau...@gmail.com> > ---
Scott, I found this is assigned to me in patchwork. Is it ok if I apply it ? Best regards, Stefano -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot