On Thu, 9 Apr 2009 05:32:29 -0700 (PDT) rudresh <[email protected]> wrote:
> > Hi All, > > I am try to use the u-boot version 2009 for MPC8313ERB broad, when i load > the u-boot.bin to board using JTAG and restart the board at that time its > not booting properly . its generated following error what may be the > problem. > > U-Boot 2009.03 (Apr 22 2009 - 04:59:44) MPC83XX > > Reset Status: Software Hard, External/Internal Soft, External/Internal Hard > > CPU: e300c3, MPC8313E, Rev: 1.0 at 333.333 MHz, CSB: 166.667 MHz > Board: Freescale MPC8313ERDB > I2C: ready > DRAM: 128 MB > FLASH: 16 MB > NAND: 256 MiB > *** Warning - bad CRC, using default environment > > In: serial > Out: serial > Err: serial > Machine check in kernel mode. > Caused by (from msr): regs 07f36df0 Unknown values in msr > NIP: 07FE9474 XER: 00000000 LR: 07FE946C REGS: 07f36df0 TRAP: 0200 DAR: > 00000000 can you turn on debugging and/or somehow find out what code is at or around the NIP address above? Also, how, if any, is this board different from Freescale's MPC8313ERDB? earlier you state it is a custom board... Kim _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
