It is a microblaze on a Xilinx Virtex 5. Not sure what the MAC is unless it is built into the VITESSE vsc8211 PHY...
The only code on the machine at this time is the UBoot 1.2 image, no linux kernel. I was led to believe by the documentation that I could boot the whole image via nfs, I am faced with a situation where tftp is not allowed so I was thinking this could be the alternative. (I have a working linux image, I am just looking for an alternative route to get it to the board.) My command is nfs 0x80000000 xxx.xxx.50.21:/root/Desktop/susenfs/bootme4linux.bin For what you are saying with the rsize= parameter I wouldn't use this command but rather change the bootargs parameter like this... setenv bootargs root=?? rw nfsroot=177.174.50.21:/root/Desktop/susenfs/bootme4linux.bin,rsize=512,wsize=512,nolock ip=177.174.50.151 and then do a loadb Without the kernel there what would my root= parameter be? On Wed, Apr 22, 2009 at 2:05 PM, Ben Warren <[email protected]> wrote: > Hi Christopher, > > christopher.mcnamara wrote: >> >> I'm having trouble booting my linux image over a nfs share. The share is >> on an openSuse 11 server. I am able to mount the folder on a >> centOS machine and copy the file over the network so I believe it is setup >> properly. My >> UBoot output is >> >> File transfer via NFS from server xxx.xxx.50.21; our IP address is >> xxx.xxx.50.15 >> 1 >> Filename '/root/Desktop/susenfs/bootme4linux.bin'. >> Load address: 0x80000000 >> Loading: ################################################################# >> #Timeout >> >> When I try a nfs share on the CentOS machine it times out immediately. >> Anyone ever seen this? >> >> UBoot 1.2.0, however the NFS code is the same. >> >> Is the the correct way to activate NFS in my uboot image? >> >> #define CONFIG_COMMANDS ( \ >> CONFIG__CMD_DFL | \ >> CFG_CMD_NET | \ >> CFG_CMD_PING | \ >> CFG_CMD_MII | \ >> CFG_CMD_DHCP | \ >> CFG_CMD_MEMORY | \ >> CFG_CMD_NFS) >> > > What processor and Ethernet controller are you using? NFS initially bursts > a lot of full-size frames and if your MAC can't keep up you'll have trouble > connecting. Try limiting the read block size on the client by specifying > 'rsize=' parameter. > > regards, > Ben > > _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
