Existing eSDHC SPL framework assumes booting from sd-image
with boot_format header which contains final u-boot Image
offset and size. No such header is present in case of
corenet devices like T1040 as corenet deivces use PBI-RCW
based intialization.
So, for corenet deives, SPL bootloader use values provided
at compilation time. These values can be defined in board
specific config file.
Signed-off-by: Priyanka Jain <priyanka.j...@freescale.com>
---
Changes for v3:
Send as independent patch (not as part of patch set)
Changes for v2:
Updated description based on Sun York's inputs
drivers/mmc/fsl_esdhc_spl.c | 5 +++++
1 files changed, 5 insertions(+), 0 deletions(-)
diff --git a/drivers/mmc/fsl_esdhc_spl.c b/drivers/mmc/fsl_esdhc_spl.c
index 65c52a2..8fc263f 100644
--- a/drivers/mmc/fsl_esdhc_spl.c
+++ b/drivers/mmc/fsl_esdhc_spl.c
@@ -42,6 +42,10 @@ void __noreturn mmc_boot(void)
hang();
}
+#ifdef CONFIG_FSL_CORENET
+ offset = CONFIG_SYS_MMC_U_BOOT_OFFS;
+ code_len = CONFIG_SYS_MMC_U_BOOT_SIZE;
+#else
blklen = mmc->read_bl_len;
tmp_buf = malloc(blklen);
if (!tmp_buf) {
@@ -91,6 +95,7 @@ void __noreturn mmc_boot(void)
/*
* Load U-Boot image from mmc into RAM
*/
+#endif
blk_start = ALIGN(offset, mmc->read_bl_len) / mmc->read_bl_len;
blk_cnt = ALIGN(code_len, mmc->read_bl_len) / mmc->read_bl_len;
err = mmc->block_dev.block_read(0, blk_start, blk_cnt,
--
1.7.4.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
