hi,
I got things working on UART2 as console....but i still have issues in
relocating..
its problem in my hardware...so things are going on well...
thank u Mr.Stefan for the help extended........
Thanks & Regards,
Prathika R
prathika wrote:
hi,
i did add the UART2 in the serial multi infrastructure at the end of
my serial.c.
i have also configured GPIO registers for enabling UART2 Tx and Rx lines.
As I understand, these lines are also multiplexed with the boot strap
lines of the PowerPC 440EP. Will this create any issue in the
performance?
As I already mentioned I have enabled #define CONFIG_UART2_CONSOLE and
#define UART2_BASE CFG_PERIPHERAL_BASE + 0x500
You have mentioned to enable the UART2 as default stdin and
stdout...where do I enable that??
Thanks & Regards,
Prathika R
Stefan Roese wrote:
On Friday 17 April 2009, prathika wrote:
i have ported u-boot this way to my board with few changes in the
u-boot
source code and the board is up and i have tested stand alone
application execution also.
So you did a "real" board port to your custom board? Or did you
"just" change the yosemite files?
Now as my requirement is that my console should be on UART2 as my UART0
and UART1 are coming out as RS 422 lines and only UART2 is RS232. I did
some patch up work on UART0 lines and tested my u-boot porting.
Ah, I though you wanted the console on UART1. Ok, then my solution
does not work for you.
I added a line
#define UART2_BASE CFG_PERIPHERAL_BASE + 0x500
I have now changed as below and I commented checking for #define
UART0_CONSOLE and #define UART1_CONSOLE:
#define UARTBASE UART2_BASE
Is this OK??
Best would be to add the 3rd UART (UART2) to the SERIAL_MULTI
infrastructure (see end of serial.c) and use this device as
"stdin/stdout/.." in your default environment.
Best regards,
Stefan
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [email protected]
=====================================================================
------------------------------------------------------------------------
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
