Hi Albert, On Wed, Jan 8, 2014 at 10:44 PM, Albert ARIBAUD <[email protected]> wrote: > Hi Jagannadha, > > On Wed, 8 Jan 2014 15:53:07 +0530, Jagannadha Sutradharudu Teki > <[email protected]> wrote: > >> These changes are from u-boot-xlnx.git repo from git.xilinx.com >> and in addition of basic fdt support. This repo is well tested >> on xilinx zynq platform, hence pushing the same on upstream. >> >> Excluded qspi and nand changes from previous series. >> >> Please note that all this series available in u-boot-spi.git/master-xlnx >> repo. >> >> -- >> Thanks, >> Jagan. >> >> Changes for v4: >> - rebase to master >> - Removed CONFIG_SYS_NO_FLASH in zynq-common.h > > As the series was rebased tu u-boot/master, not u-boot-arm/master, > all patches adding board support failed to apply properly due to > boards.cfg differences. Yes - I saw this i'll rebase your u-boot-arm/master then.
> > I did resolve these manually, but at build-test time, all Zynq boards > failed with "Makefile:11: *** Please define CONFIG_DEFAULT_DEVICE_TREE > in your board header file. Stop." -- and were the only ones to do so. Actually build will successful when you give the dts at runtime while building u-boot like Linux style. $ make DEVICE_TREE=<dts_file_name> ex: make DEVICE_TREE=zynq-zc702 This is the reason I am not defining this on individual pre-board configs. I guess this could be fine, please comment. -- Thanks, Jagan. _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
