Add support for the Kona SDHCI found on Broadcom mobile SoCs.
Signed-off-by: Darwin Rambo <dra...@broadcom.com>
Reviewed-by: Steve Rae <s...@broadcom.com>
Reviewed-by: Tim Kryger <tkry...@linaro.org>
---
drivers/mmc/Makefile | 1 +
drivers/mmc/kona_sdhci.c | 125 ++++++++++++++++++++++++++++++++++++++++++++++
2 files changed, 126 insertions(+)
create mode 100644 drivers/mmc/kona_sdhci.c
diff --git a/drivers/mmc/Makefile b/drivers/mmc/Makefile
index e793ed9..931922b 100644
--- a/drivers/mmc/Makefile
+++ b/drivers/mmc/Makefile
@@ -21,6 +21,7 @@ obj-$(CONFIG_OMAP_HSMMC) += omap_hsmmc.o
obj-$(CONFIG_PXA_MMC_GENERIC) += pxa_mmc_gen.o
obj-$(CONFIG_SDHCI) += sdhci.o
obj-$(CONFIG_BCM2835_SDHCI) += bcm2835_sdhci.o
+obj-$(CONFIG_KONA_SDHCI) += kona_sdhci.o
obj-$(CONFIG_S5P_SDHCI) += s5p_sdhci.o
obj-$(CONFIG_SH_MMCIF) += sh_mmcif.o
obj-$(CONFIG_SPEAR_SDHCI) += spear_sdhci.o
diff --git a/drivers/mmc/kona_sdhci.c b/drivers/mmc/kona_sdhci.c
new file mode 100644
index 0000000..69e6f17
--- /dev/null
+++ b/drivers/mmc/kona_sdhci.c
@@ -0,0 +1,125 @@
+/*
+ * Copyright 2013 Broadcom Corporation. All rights reserved.
+ *
+ * SPDX-License-Identifier: GPL-2.0+
+ */
+
+#include <common.h>
+#include <malloc.h>
+#include <sdhci.h>
+#include <asm/errno.h>
+#include <asm/kona-common/clk.h>
+
+#define SDHCI_CORECTRL_OFFSET 0x00008000
+#define SDHCI_CORECTRL_EN 0x01
+#define SDHCI_CORECTRL_RESET 0x02
+
+#define SDHCI_CORESTAT_OFFSET 0x00008004
+#define SDHCI_CORESTAT_CD_SW 0x01
+
+#define SDHCI_COREIMR_OFFSET 0x00008008
+#define SDHCI_COREIMR_IP 0x01
+
+static int init_mmc_core(struct sdhci_host *host)
+{
+ unsigned int mask;
+ unsigned int timeout;
+
+ if (sdhci_readb(host, SDHCI_SOFTWARE_RESET) & SDHCI_RESET_ALL) {
+ printf("%s: sd host controller reset error\n", __func__);
+ return 1;
+ }
+
+ /* For kona a hardware reset before anything else. */
+ mask = sdhci_readl(host, SDHCI_CORECTRL_OFFSET) | SDHCI_CORECTRL_RESET;
+ sdhci_writel(host, mask, SDHCI_CORECTRL_OFFSET);
+
+ /* Wait max 100 ms */
+ timeout = 1000;
+ do {
+ if (timeout == 0) {
+ printf("%s: reset timeout error\n", __func__);
+ return 1;
+ }
+ timeout--;
+ udelay(100);
+ } while (0 ==
+ (sdhci_readl(host, SDHCI_CORECTRL_OFFSET) &
+ SDHCI_CORECTRL_RESET));
+
+ /* Clear the reset bit. */
+ mask = mask & ~SDHCI_CORECTRL_RESET;
+ sdhci_writel(host, mask, SDHCI_CORECTRL_OFFSET);
+ udelay(10);
+
+ /* Enable AHB clock */
+ mask = sdhci_readl(host, SDHCI_CORECTRL_OFFSET);
+ sdhci_writel(host, mask | SDHCI_CORECTRL_EN, SDHCI_CORECTRL_OFFSET);
+
+ /* Enable interrupts */
+ sdhci_writel(host, SDHCI_COREIMR_IP, SDHCI_COREIMR_OFFSET);
+
+ /* Make sure Card is detected in controller */
+ mask = sdhci_readl(host, SDHCI_CORESTAT_OFFSET);
+ sdhci_writel(host, mask | SDHCI_CORESTAT_CD_SW, SDHCI_CORESTAT_OFFSET);
+
+ return 0;
+}
+
+int kona_sdhci_init(int dev_index, u32 min_clk, u32 quirks)
+{
+ int ret = 0;
+ u32 max_clk;
+ void *reg_base;
+ struct sdhci_host *host = NULL;
+
+ host = (struct sdhci_host *)malloc(sizeof(struct sdhci_host));
+ if (!host) {
+ printf("%s: sdhci host malloc fail!\n", __func__);
+ return -ENOMEM;
+ }
+ switch (dev_index) {
+ case 0:
+ reg_base = (void *)CONFIG_SYS_SDIO_BASE0;
+ ret = clk_sdio_enable(reg_base, CONFIG_SYS_SDIO0_MAX_CLK,
+ &max_clk);
+ break;
+ case 1:
+ reg_base = (void *)CONFIG_SYS_SDIO_BASE1;
+ ret = clk_sdio_enable(reg_base, CONFIG_SYS_SDIO1_MAX_CLK,
+ &max_clk);
+ break;
+ case 2:
+ reg_base = (void *)CONFIG_SYS_SDIO_BASE2;
+ ret = clk_sdio_enable(reg_base, CONFIG_SYS_SDIO2_MAX_CLK,
+ &max_clk);
+ break;
+ case 3:
+ reg_base = (void *)CONFIG_SYS_SDIO_BASE3;
+ ret = clk_sdio_enable(reg_base, CONFIG_SYS_SDIO3_MAX_CLK,
+ &max_clk);
+ break;
+ default:
+ printf("%s: sdio dev index %d not supported\n",
+ __func__, dev_index);
+ ret = -EINVAL;
+ }
+ if (ret)
+ return ret;
+
+ host->name = "kona-sdhci";
+ host->ioaddr = reg_base;
+ host->quirks = quirks;
+ host->host_caps = MMC_MODE_HC;
+
+ if (init_mmc_core(host))
+ return -EINVAL;
+
+ if (quirks & SDHCI_QUIRK_REG32_RW)
+ host->version = sdhci_readl(host, SDHCI_HOST_VERSION - 2) >> 16;
+ else
+ host->version = sdhci_readw(host, SDHCI_HOST_VERSION);
+
+ add_sdhci(host, max_clk, min_clk);
+ return ret;
+}
--
1.7.9.5
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
