Hi Andrew, On Apr 3, 2014, at 12:34 PM, Andrew Gabbasov wrote:
> MMC switch command for unsupported feature (e.g. bus width) sets a switch > error bit in card status. This bit should be checked, and, if it's set, > no access with new controller settings should be performed. > > Signed-off-by: Andrew Gabbasov <andrew_gabba...@mentor.com> > --- > drivers/mmc/mmc.c | 4 +++- > include/mmc.h | 2 ++ > 2 files changed, 5 insertions(+), 1 deletion(-) > > diff --git a/drivers/mmc/mmc.c b/drivers/mmc/mmc.c > index 16051e5..a850085 100644 > --- a/drivers/mmc/mmc.c > +++ b/drivers/mmc/mmc.c > @@ -150,6 +150,8 @@ int mmc_send_status(struct mmc *mmc, int timeout) > #endif > return TIMEOUT; > } > + if (cmd.response[0] & MMC_STATUS_SWITCH_ERROR) > + return SWITCH_ERR; > > return 0; > } > @@ -501,7 +503,7 @@ static int mmc_change_freq(struct mmc *mmc) > err = mmc_switch(mmc, EXT_CSD_CMD_SET_NORMAL, EXT_CSD_HS_TIMING, 1); > > if (err) > - return err; > + return err == SWITCH_ERR ? 0 : err; > > /* Now check to see that it worked */ > err = mmc_send_ext_csd(mmc, ext_csd); > diff --git a/include/mmc.h b/include/mmc.h > index c0a1d9e..213c112 100644 > --- a/include/mmc.h > +++ b/include/mmc.h > @@ -53,6 +53,7 @@ > #define COMM_ERR -18 /* Communications Error */ > #define TIMEOUT -19 > #define IN_PROGRESS -20 /* operation is in progress */ > +#define SWITCH_ERR -21 /* Card reports failure to switch mode */ > > #define MMC_CMD_GO_IDLE_STATE 0 > #define MMC_CMD_SEND_OP_COND 1 > @@ -108,6 +109,7 @@ > #define SECURE_ERASE 0x80000000 > > #define MMC_STATUS_MASK (~0x0206BF7F) > +#define MMC_STATUS_SWITCH_ERROR (1 << 7) > #define MMC_STATUS_RDY_FOR_DATA (1 << 8) > #define MMC_STATUS_CURR_STATE (0xf << 9) > #define MMC_STATUS_ERROR (1 << 19) > -- > 1.7.10.4 > Applied, Thanks --Pantelis Acked-by: Pantelis Antoniou <pa...@antoniou-consulting.com> _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
