On 19:58 Mon 11 May , David Brownell wrote: > From: David Brownell <[email protected]> > > Initial U-Boot support for the DaVinci DM355 EVM. This is a board > from Spectrum Digital. Board docs include schematic and firmware > for its microcontroller: > > http://c6000.spectrumdigital.com/evmdm355/revd/ > > Most of the DM355 chip is fully documented by TI, the most notable > exception being the MPEG/JPEG coprocessor (programmable using codecs > available at no cost from TI), which is omitted from its DM335 sibling: > > http://focus.ti.com/docs/prod/folders/print/tms320dm355.html > > This version can boot from the on-board DM9000 Ethernet chip, after > being loaded (from NAND, MMC/SD, or UART). In the near future, NAND > and USB support could be added ... NAND support is being held back > until the support for the 4-bit ECC hardware is ready. > > Signed-off-by: David Brownell <[email protected]> > --- Applied to arm/next
Best Regards, J. _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
