Hi Vishal,
> I am new to uBoot.
Welcome.
> I am using the sbc2410x board. I successfully compiled the uboot-1.1.6 for
> this board. But after downloading the uboot.bin to the flash, i am not
> getting the uboot prompt on serial terminal.
As Wolfgang said - in the long run switching to latest code is a must if
you want to get free support.
> I am using the NAND flash. Do i have to make the changes for NAND flash and
> recompile the uboot?
Actually I doubt that this board support had a NAND boot in mind - but
looking at include/configs/sbc2410x.h only JinHua Luo will know for
sure, so I put him on CC.
Cheers
Detlev
--
Computers are useless. They can only give you answers.
-- Pablo Picasso
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-40 Fax: (+49)-8142-66989-80 Email: [email protected]
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
