Hello Tiger, On 07/30/2014 01:44 PM, [email protected] wrote:
Hi, singh:I have an Origen(Cortex-A9 Dual Core, Exynos 4210) development board.(InSignal produced) I followed below steps to verify the latest u-boot release code: 1. build uboot make origen_config make all then it will origen-spl.bin in spl dir. 2. run "dd" command to burn raw images into a SD Card. dd iflag=dsync oflag=dsync if=./origen-spl.bin of=/dev/sdb bs=512
The first block of SD card is reserved for a partition table. You missed seek=1 in above command - this should helps.
dd iflag=dsync oflag=dsync if=./u-boot.bin of=/dev/sdb bs=512 seek=65 but nothing appeared in a UART terminal. Best wishes, _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
Best regards, -- Przemyslaw Marczak Samsung R&D Institute Poland Samsung Electronics [email protected] _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
