Hi, On 11 August 2014 02:20, Nikita Kiryanov <nik...@compulab.co.il> wrote: > Hi Simon, > > > On 11/08/14 03:11, Simon Glass wrote: >> >> Hi Nikita, >> >> On 10 August 2014 11:12, Nikita Kiryanov <nik...@compulab.co.il> wrote: >>> >>> This partial V2 completes the previous partial V2. It contains some final >>> preparational steps, and the introduction of cm-fx6 board. >>> >>> Changes in V2: >>> - Update commit message of "arm: mx6: ddr: configure MMDC for >>> slow_pd" >>> - Remove unnecessary line removal from >>> arch/arm/cpu/armv7/mx6/ddr.c >>> - Move probe_mmdc_config() code straight to dram_init() >>> - Use imx6_spl.h >>> - Use imx_ddr_size() >>> NOTE: the correction of this patch now depends on >>> https://patchwork.ozlabs.org/patch/376095/ >> >> >> Does this series support the dual core Utilite machine? > > > It does support dual core, but not the Utilite boot sequence. Right now > you can only boot from MMC because SPL has no fallback functionality and > Utilite always tries MMC first. I'll be sending patches for that after > this series is accepted. > > >> If so I'm not sure how to enable dual core instead of quad core - any >> ideas please? > > > You don't need to do anything to run this on dual core. ...or am I > misunderstanding your question?
I'm not sure. It was failing to boot from SD and I thought that might be the problems, since I see quite a few CPU-related configs in the board config file. Is there a canonical description of how to making a boot image and put it on SD? Perhaps I was doing that incorrectly. Thanks, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot