From: Fabio Estevam <[email protected]>

Let PCI on mx6solox also be supported.

Signed-off-by: Fabio Estevam <[email protected]>
---
 arch/arm/cpu/armv7/mx6/clock.c        |  9 ++++++++
 arch/arm/include/asm/arch-mx6/iomux.h |  9 ++++++++
 drivers/pci/pcie_imx.c                | 40 +++++++++++++++++++++++++++++++----
 3 files changed, 54 insertions(+), 4 deletions(-)

diff --git a/arch/arm/cpu/armv7/mx6/clock.c b/arch/arm/cpu/armv7/mx6/clock.c
index abd9d61..dd628d8 100644
--- a/arch/arm/cpu/armv7/mx6/clock.c
+++ b/arch/arm/cpu/armv7/mx6/clock.c
@@ -504,10 +504,19 @@ int enable_pcie_clock(void)
 #define ANADIG_ANA_MISC1_LVDSCLK1_IBEN         (1 << 12)
 #define ANADIG_ANA_MISC1_LVDSCLK1_OBEN         (1 << 10)
 #define ANADIG_ANA_MISC1_LVDS1_CLK_SEL_MASK    0x0000001F
+#ifndef CONFIG_MX6SX
+       /* lvds_clk1 is sourced from sata ref on imx6q/dl/solo */
        clrsetbits_le32(&anatop_regs->ana_misc1,
                        ANADIG_ANA_MISC1_LVDSCLK1_IBEN |
                        ANADIG_ANA_MISC1_LVDS1_CLK_SEL_MASK,
                        ANADIG_ANA_MISC1_LVDSCLK1_OBEN | 0xb);
+#else
+       /* lvds_clk1 is sourced from pcie ref on imx6sx */
+       clrsetbits_le32(&anatop_regs->ana_misc1,
+                       ANADIG_ANA_MISC1_LVDSCLK1_IBEN |
+                       ANADIG_ANA_MISC1_LVDS1_CLK_SEL_MASK,
+                       ANADIG_ANA_MISC1_LVDSCLK1_OBEN | 0xa);
+#endif
 
        /* PCIe reference clock sourced from AXI. */
        clrbits_le32(&ccm_regs->cbcmr, MXC_CCM_CBCMR_PCIE_AXI_CLK_SEL);
diff --git a/arch/arm/include/asm/arch-mx6/iomux.h 
b/arch/arm/include/asm/arch-mx6/iomux.h
index 6a4a632..c86aa31 100644
--- a/arch/arm/include/asm/arch-mx6/iomux.h
+++ b/arch/arm/include/asm/arch-mx6/iomux.h
@@ -19,6 +19,12 @@
 #define IOMUXC_GPR1_TEST_POWERDOWN             (1 << 18)
 
 /*
+ * IOMUXC_GPR5 bit fields
+ */
+#define IOMUXC_GPR5_PCIE_BTNRST                        (1 << 19)
+#define IOMUXC_GPR5_PCIE_PERST                 (1 << 18)
+
+/*
  * IOMUXC_GPR8 bit fields
  */
 #define IOMUXC_GPR8_PCS_TX_DEEMPH_GEN1_MASK            (0x3f << 0)
@@ -35,12 +41,15 @@
 /*
  * IOMUXC_GPR12 bit fields
  */
+#define IOMUXC_GPR12_RX_EQ_2                   (0x2 << 0)
+#define IOMUXC_GPR12_RX_EQ_MASK                        (0x7 << 0)
 #define IOMUXC_GPR12_LOS_LEVEL_9               (0x9 << 4)
 #define IOMUXC_GPR12_LOS_LEVEL_MASK            (0x1f << 4)
 #define IOMUXC_GPR12_APPS_LTSSM_ENABLE         (1 << 10)
 #define IOMUXC_GPR12_DEVICE_TYPE_EP            (0x0 << 12)
 #define IOMUXC_GPR12_DEVICE_TYPE_RC            (0x4 << 12)
 #define IOMUXC_GPR12_DEVICE_TYPE_MASK          (0xf << 12)
+#define IOMUXC_GPR12_TEST_POWERDOWN            (1 << 30)
 
 /*
  * IOMUXC_GPR13 bit fields
diff --git a/drivers/pci/pcie_imx.c b/drivers/pci/pcie_imx.c
index a3982c4..3f89026 100644
--- a/drivers/pci/pcie_imx.c
+++ b/drivers/pci/pcie_imx.c
@@ -23,13 +23,20 @@
 #define PCI_ACCESS_READ  0
 #define PCI_ACCESS_WRITE 1
 
+#ifdef CONFIG_MX6SX
+#define MX6_DBI_ADDR   0x08ffc000
+#define MX6_IO_ADDR    0x08000000
+#define MX6_MEM_ADDR   0x08100000
+#define MX6_ROOT_ADDR  0x08f00000
+#else
 #define MX6_DBI_ADDR   0x01ffc000
-#define MX6_DBI_SIZE   0x4000
 #define MX6_IO_ADDR    0x01000000
-#define MX6_IO_SIZE    0x100000
 #define MX6_MEM_ADDR   0x01100000
-#define MX6_MEM_SIZE   0xe00000
 #define MX6_ROOT_ADDR  0x01f00000
+#endif
+#define MX6_DBI_SIZE   0x4000
+#define MX6_IO_SIZE    0x100000
+#define MX6_MEM_SIZE   0xe00000
 #define MX6_ROOT_SIZE  0xfc000
 
 /* PCIe Port Logic registers (memory-mapped) */
@@ -421,9 +428,21 @@ static int imx_pcie_write_config(struct pci_controller 
*hose, pci_dev_t d,
 static int imx6_pcie_assert_core_reset(void)
 {
        struct iomuxc *iomuxc_regs = (struct iomuxc *)IOMUXC_BASE_ADDR;
-
+       struct gpc *gpc_regs = (struct gpc *)GPC_BASE_ADDR;
+#if defined(CONFIG_MX6SX)
+       /* SSP_EN is not used on MX6SX anymore */
+       setbits_le32(&iomuxc_regs->gpr[12], IOMUXC_GPR12_TEST_POWERDOWN);
+       /* Force PCIe PHY reset */
+       setbits_le32(&iomuxc_regs->gpr[5], IOMUXC_GPR5_PCIE_BTNRST);
+
+       /* Power up PCIe PHY, ANATOP_REG_CORE offset 0x140, bits 13-9 */
+       int val = readl(&gpc_regs->cntr);
+       val |= (0x1 << 7);
+       writel(val, &gpc_regs->cntr);
+#else
        setbits_le32(&iomuxc_regs->gpr[1], IOMUXC_GPR1_TEST_POWERDOWN);
        clrbits_le32(&iomuxc_regs->gpr[1], IOMUXC_GPR1_REF_SSP_EN);
+#endif
 
        return 0;
 }
@@ -441,6 +460,12 @@ static int imx6_pcie_init_phy(void)
                        IOMUXC_GPR12_LOS_LEVEL_MASK,
                        IOMUXC_GPR12_LOS_LEVEL_9);
 
+#ifdef CONFIG_MX6SX
+       clrsetbits_le32(&iomuxc_regs->gpr[12],
+                       IOMUXC_GPR12_RX_EQ_MASK,
+                       IOMUXC_GPR12_RX_EQ_2);
+#endif
+
        writel((0x0 << IOMUXC_GPR8_PCS_TX_DEEMPH_GEN1_OFFSET) |
               (0x0 << IOMUXC_GPR8_PCS_TX_DEEMPH_GEN2_3P5DB_OFFSET) |
               (20 << IOMUXC_GPR8_PCS_TX_DEEMPH_GEN2_6DB_OFFSET) |
@@ -517,9 +542,16 @@ static int imx6_pcie_deassert_core_reset(void)
         */
        mdelay(50);
 
+#if defined(CONFIG_MX6SX)
+       /* SSP_EN is not used on MX6SX anymore */
+       clrbits_le32(&iomuxc_regs->gpr[12], IOMUXC_GPR12_TEST_POWERDOWN);
+       /* Unlike mx6q/dl/solo , mx6solox has a PCI reset bit */
+       clrbits_le32(&iomuxc_regs->gpr[5], IOMUXC_GPR5_PCIE_BTNRST);
+#else
        /* Enable PCIe */
        clrbits_le32(&iomuxc_regs->gpr[1], IOMUXC_GPR1_TEST_POWERDOWN);
        setbits_le32(&iomuxc_regs->gpr[1], IOMUXC_GPR1_REF_SSP_EN);
+#endif
 
        imx6_pcie_toggle_reset();
 
-- 
1.9.1

_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to