On 28 August 2014 16:46, Peter Crosthwaite <[email protected]> wrote: > From: Tinghui Wang <[email protected]> > > This patch adds config support needed for ZYBO target and has > been tested on Rev. B ZYBO hardware. > > Signed-off-by: Tinghui Wang <[email protected]> > [PC changes: > * Dropped boards.cfg change (rebase conflict) > * Dropped custom u-boot env > * Added DTS > * Misc forward-porting changes > ] > Signed-off-by: Peter Crosthwiate <[email protected]> > > --- > I have dropped the custom u-boot env from the original patch, > as I'm not sure what the purpose was and I didn't need it for ZYBO SPL. > --- > include/configs/zynq_zybo.h | 31 +++++++++++++++++++++++++++++++ > 1 file changed, 31 insertions(+) > create mode 100644 include/configs/zynq_zybo.h > > diff --git a/include/configs/zynq_zybo.h b/include/configs/zynq_zybo.h > new file mode 100644 > index 0000000..c167207 > --- /dev/null > +++ b/include/configs/zynq_zybo.h > @@ -0,0 +1,31 @@ > +/* > + * (C) Copyright 2012 Xilinx > + * (C) Copyright 2014 Digilent Inc. > + * > + * Configuration for Zynq Development Board - ZYBO > + * See zynq_common.h for Zynq common configs
typo - it's zynq-common.h > + * > + * SPDX-License-Identifier: GPL-2.0+ > + */ > + > +#ifndef __CONFIG_ZYNQ_ZYBO_H > +#define __CONFIG_ZYNQ_ZYBO_H > + > +#define CONFIG_SYS_SDRAM_SIZE (512 * 1024 * 1024) > + > +#define CONFIG_ZYNQ_SERIAL_UART1 > +#define CONFIG_ZYNQ_GEM0 > +#define CONFIG_ZYNQ_GEM_PHY_ADDR0 0 > + > +#define CONFIG_SYS_NO_FLASH > + > +#define CONFIG_ZYNQ_SDHCI0 > +#define CONFIG_ZYNQ_BOOT_FREEBSD > +#define CONFIG_DEFAULT_DEVICE_TREE zynq-zybo > + > +/* Define ZYBO PS Clock Frequency to 50MHz */ > +#define CONFIG_ZYNQ_PS_CLK_FREQ 50000000UL > + > +#include <configs/zynq-common.h> > + > +#endif /* __CONFIG_ZYNQ_ZYBO_H */ > -- > 1.9.1 thanks! -- Jagan. _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
