On 21/08/2014 08:31, Tim Harvey wrote: > The IMX6 MMDC calibration registers depend on propagation delay and capacitive > loading between the SoC's MMDC and the DDR3 chips. On the Ventana boards the > board layout varies little in trace-lengths such that propagation delays are > irrelevant thus we can simply things by using calibration values obtained > from various board layouts based on a common SoC and DDR chip configuration. > > This eliminates board-model from being needed allowing more flexibility. These > values were tested on a large sample size of Gateworks Ventana boards ranging > in layout, and memory configuration over the entire temperature range > supported. > > Signed-off-by: Tim Harvey <[email protected]> > ---
Applied to u-boot-imx, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: [email protected] ===================================================================== _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
