device ready pin is signalling that the device is ready on state 1
not on 0. Simmiliar as it is in drivers/mtd/nand/nand_spl_simple.c
Signed-off-by: Heiko Schocher <h...@denx.de>
Reviewed-by: Andreas Bießmann <andreas.de...@googlemail.com>
---
Changes in v2:
add Reviewed-by: Andreas Bießmann <andreas.de...@googlemail.com>
drivers/mtd/nand/atmel_nand.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index d6d6f85..3b6093a 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c
@@ -1188,7 +1188,7 @@ static int nand_command(int block, int page, uint32_t
offs, u8 cmd)
void (*hwctrl)(struct mtd_info *mtd, int cmd,
unsigned int ctrl) = this->cmd_ctrl;
- while (this->dev_ready(&mtd))
+ while (!this->dev_ready(&mtd))
;
if (cmd == NAND_CMD_READOOB) {
@@ -1213,7 +1213,7 @@ static int nand_command(int block, int page, uint32_t
offs, u8 cmd)
hwctrl(&mtd, NAND_CMD_READSTART, NAND_CTRL_CLE | NAND_CTRL_CHANGE);
hwctrl(&mtd, NAND_CMD_NONE, NAND_NCE | NAND_CTRL_CHANGE);
- while (this->dev_ready(&mtd))
+ while (!this->dev_ready(&mtd))
;
return 0;
@@ -1353,7 +1353,7 @@ int at91_nand_wait_ready(struct mtd_info *mtd)
udelay(this->chip_delay);
- return 0;
+ return 1;
}
int board_nand_init(struct nand_chip *nand)
--
1.8.3.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
