On 10/11/2014 14:35, Christian Gmeiner wrote: > U-Boot 2014.10-17457-g0b23780-dirty (Nov 10 2014 - 11:41:04) > > CPU: Freescale i.MX6D rev1.2 at 792 MHz > Reset cause: WDOG > Board: ot1200 > I2C: ready > DRAM: 1 GiB > MMC: FSL_SDHC: 0, FSL_SDHC: 1 > SF: Detected M25P16 with page size 256 Bytes, erase size 64 KiB, total 2 MiB > In: serial > Out: serial > Err: serial > Net: using phy at 0 > FEC [PRIME] > Hit any key to stop autoboot: 0 > => usb start > (Re)start USB... > USB0: Port not available. > USB1: USB EHCI 1.00 > scanning bus 1 for devices... 4 USB Device(s) found > => usb tree > USB device tree: > 1 Hub (480 Mb/s, 0mA) > | u-boot EHCI Host Controller > | > +-2 Hub (480 Mb/s, 2mA) > | > +-3 Mass Storage (480 Mb/s, 80mA) > | USBest Technology USB Mass Storage Device 0000000000028B > | > +-4 Vendor specific (480 Mb/s, 2mA) > > => > > Signed-off-by: Christian Gmeiner <[email protected]> > ---
Applied to u-boot-imx, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: [email protected] ===================================================================== _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
