From: Fabio Estevam <fabio.este...@freescale.com>
When an invalid USDHC port is passed we should return -EINVAL instead of 0.
Also, return the error immediately on fsl_esdhc_initialize() failure.
Signed-off-by: Fabio Estevam <fabio.este...@freescale.com>
---
board/wandboard/wandboard.c | 10 ++++++----
1 file changed, 6 insertions(+), 4 deletions(-)
diff --git a/board/wandboard/wandboard.c b/board/wandboard/wandboard.c
index 3c8b7a5..1075c65 100644
--- a/board/wandboard/wandboard.c
+++ b/board/wandboard/wandboard.c
@@ -144,7 +144,7 @@ int board_mmc_getcd(struct mmc *mmc)
int board_mmc_init(bd_t *bis)
{
- s32 status = 0;
+ int ret;
u32 index = 0;
/*
@@ -173,13 +173,15 @@ int board_mmc_init(bd_t *bis)
printf("Warning: you configured more USDHC controllers"
"(%d) then supported by the board (%d)\n",
index + 1, CONFIG_SYS_FSL_USDHC_NUM);
- return status;
+ return -EINVAL;
}
- status |= fsl_esdhc_initialize(bis, &usdhc_cfg[index]);
+ ret = fsl_esdhc_initialize(bis, &usdhc_cfg[index]);
+ if (ret)
+ return ret;
}
- return status;
+ return 0;
}
static int mx6_rgmii_rework(struct phy_device *phydev)
--
1.9.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
