Hi, On 2 December 2014 at 00:07, Hyungwon Hwang <[email protected]> wrote: > From: Sjoerd Simons <[email protected]> > > Add samsung,vbus-gpio information for the XU3. This allows the usage of > the EHCI controller on the XU3, which is connected to the SMSC LAN9514 > chip (usb hub + network). > > Note that this patch doesn't enable support for USB/USB networking in > the default config as makes the u-boot binary too big for the current odroid > setup. > > Signed-off-by: Sjoerd Simons <[email protected]> > Signed-off-by: Hyungwon Hwang <[email protected]> > Cc: Minkyu Kang <[email protected]> > Cc: Lukasz Majewski <[email protected]> > Cc: Sjoerd Simons <[email protected]> > Cc: Javier Martinez Canillas <[email protected]> > Cc: Simon Glass <[email protected]> > --- > Changes for v10: > - Newly added > > arch/arm/dts/exynos5422-odroidxu3.dts | 4 ++++ > 1 file changed, 4 insertions(+) > > diff --git a/arch/arm/dts/exynos5422-odroidxu3.dts > b/arch/arm/dts/exynos5422-odroidxu3.dts > index cff32a9..be20f1b 100644 > --- a/arch/arm/dts/exynos5422-odroidxu3.dts > +++ b/arch/arm/dts/exynos5422-odroidxu3.dts > @@ -31,6 +31,10 @@ > 0xb0000000 0xea00000>; > }; > > + ehci@12110000 { > + samsung,vbus-gpio = <&gpio 0x316 0>; /* X26 */
Are you sure this is right? By my count this should be 0x66, not 0x316. This might be historical. It almost feels like you could drop this patch until you actually have working USB support. Regards, Simon _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
