Add support for using PORTD hsync/vsync pins with tcon1, this is a preparation patch for adding native VGA support.
Signed-off-by: Hans de Goede <[email protected]> --- drivers/video/sunxi_display.c | 22 +++++++++++++++++++--- 1 file changed, 19 insertions(+), 3 deletions(-) diff --git a/drivers/video/sunxi_display.c b/drivers/video/sunxi_display.c index 669c46c..0dd5aa1 100644 --- a/drivers/video/sunxi_display.c +++ b/drivers/video/sunxi_display.c @@ -574,11 +574,12 @@ static void sunxi_lcdc_tcon0_mode_set(const struct ctfb_res_modes *mode) #ifdef CONFIG_VIDEO_HDMI static void sunxi_lcdc_tcon1_mode_set(const struct ctfb_res_modes *mode, - int *clk_div, int *clk_double) + int *clk_div, int *clk_double, + bool use_portd_hvsync) { struct sunxi_lcdc_reg * const lcdc = (struct sunxi_lcdc_reg *)SUNXI_LCD0_BASE; - int bp, clk_delay, total; + int bp, clk_delay, total, val; /* Use tcon1 */ clrsetbits_le32(&lcdc->ctrl, SUNXI_LCDC_CTRL_IO_MAP_MASK, @@ -608,6 +609,21 @@ static void sunxi_lcdc_tcon1_mode_set(const struct ctfb_res_modes *mode, writel(SUNXI_LCDC_X(mode->hsync_len) | SUNXI_LCDC_Y(mode->vsync_len), &lcdc->tcon1_timing_sync); + if (use_portd_hvsync) { + sunxi_gpio_set_cfgpin(SUNXI_GPD(26), SUNXI_GPD0_LCD0); + sunxi_gpio_set_cfgpin(SUNXI_GPD(27), SUNXI_GPD0_LCD0); + + val = 0; + if (mode->sync & FB_SYNC_HOR_HIGH_ACT) + val |= SUNXI_LCDC_TCON_HSYNC_MASK; + if (mode->sync & FB_SYNC_VERT_HIGH_ACT) + val |= SUNXI_LCDC_TCON_VSYNC_MASK; + writel(val, &lcdc->tcon1_io_polarity); + + clrbits_le32(&lcdc->tcon1_io_tristate, + SUNXI_LCDC_TCON_VSYNC_MASK | + SUNXI_LCDC_TCON_HSYNC_MASK); + } sunxi_lcdc_pll_set(1, mode->pixclock_khz, clk_div, clk_double); } @@ -751,7 +767,7 @@ static void sunxi_mode_set(const struct ctfb_res_modes *mode, #ifdef CONFIG_VIDEO_HDMI int clk_div, clk_double; sunxi_composer_mode_set(mode, address); - sunxi_lcdc_tcon1_mode_set(mode, &clk_div, &clk_double); + sunxi_lcdc_tcon1_mode_set(mode, &clk_div, &clk_double, 0); sunxi_hdmi_mode_set(mode, clk_div, clk_double); sunxi_composer_enable(); sunxi_lcdc_enable(); -- 2.1.0 _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
