Hi Simon, On Tue, Dec 30, 2014 at 10:32 AM, Simon Glass <s...@chromium.org> wrote: > NOT TO APPLY > > This shows how to enable video for the glacier board, as an example of the > emulator working on a VESA-compliant graphics card. > > Signed-off-by: Simon Glass <s...@chromium.org> > --- > > include/configs/canyonlands.h | 31 +++++++++++++++++++++++++++++++ > 1 file changed, 31 insertions(+) > > diff --git a/include/configs/canyonlands.h b/include/configs/canyonlands.h > index 7a1499d..c55e076 100644 > --- a/include/configs/canyonlands.h > +++ b/include/configs/canyonlands.h > @@ -133,6 +133,9 @@ > #define CONFIG_SYS_NOR_CS 0 /* NOR chip connected to CSx > */ > #define CONFIG_SYS_NAND_CS 3 /* NAND chip connected to CSx > */ > > +#define CONFIG_CONSOLE_MUX > +#define CONFIG_SYS_CONSOLE_IS_IN_ENV > + > /*----------------------------------------------------------------------- > * FLASH related > *----------------------------------------------------------------------*/ > @@ -359,6 +362,15 @@ > "ramdisk_addr=fc200000\0" \ > "pciconfighost=1\0" \ > "pcie_mode=RP:RP\0" \ > + "eth1addr=00:01:ec:00:f4:9d\0" \ > + "eth2addr=00:01:ec:00:f4:9e\0" \ > + "eth3addr=00:01:ec:00:f4:9f\0" \ > + "ethact=ppc_4xx_eth0\0" \ > + "ethaddr=00:01:ec:00:f4:9c\0" \ > + "stderr=serial\0" \ > + "stdin=serial\0" \ > + "stdout=serial,vga\0" \ > + "autoload=n\0" \ > "" > #else /* defined(CONFIG_ARCHES) */ > #define CONFIG_EXTRA_ENV_SETTINGS \ > @@ -675,4 +687,23 @@ > } > #endif > > +#define CONFIG_VIDEO > + > +#ifdef CONFIG_VIDEO > +#define CONFIG_BIOSEMU /* x86 bios emulator for vga bios */ > +#define CONFIG_VIDEO_VESA > +#define VIDEO_IO_OFFSET 0xd8000000 > +#define CONFIG_SYS_ISA_IO_BASE_ADDRESS VIDEO_IO_OFFSET > +#define CONFIG_VIDEO_SW_CURSOR > +#define CONFIG_VIDEO_LOGO > +#define CONFIG_CFB_CONSOLE > +#define CONFIG_SPLASH_SCREEN > +#define CONFIG_VGA_AS_SINGLE_DEVICE > +#define CONFIG_CMD_BMP > +#endif > + > +#define CONFIG_FRAMEBUFFER_SET_VESA_MODE > +#define CONFIG_FRAMEBUFFER_VESA_MODE 0x114 > +#define CONFIG_CMD_TFTPPUT > + > #endif /* __CONFIG_H */ > --
Could you also post the codes that actually run the vga bios on ppc target? I may find another non-x86 board to test. Regards, Bin _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot