Obtain 2nd NIC MAC address from baseboard EEPROM and pass it to Linux.
Signed-off-by: Nikita Kiryanov <[email protected]>
Cc: Stefano Babic <[email protected]>
Cc: Igor Grinberg <[email protected]>
---
board/compulab/cm_fx6/cm_fx6.c | 23 ++++++++++++++++-------
1 file changed, 16 insertions(+), 7 deletions(-)
diff --git a/board/compulab/cm_fx6/cm_fx6.c b/board/compulab/cm_fx6/cm_fx6.c
index 32f4434..eb18dfc 100644
--- a/board/compulab/cm_fx6/cm_fx6.c
+++ b/board/compulab/cm_fx6/cm_fx6.c
@@ -345,32 +345,36 @@ static iomux_v3_cfg_t const enet_pads[] = {
MUX_PAD_CTRL(ENET_PAD_CTRL)),
};
-static int handle_mac_address(void)
+static int handle_mac_address(char *env_var, uint eeprom_bus)
{
unsigned char enetaddr[6];
int rc;
- rc = eth_getenv_enetaddr("ethaddr", enetaddr);
+ rc = eth_getenv_enetaddr(env_var, enetaddr);
if (rc)
return 0;
- rc = cl_eeprom_read_mac_addr(enetaddr, CONFIG_SYS_I2C_EEPROM_BUS);
+ rc = cl_eeprom_read_mac_addr(enetaddr, eeprom_bus);
if (rc)
return rc;
if (!is_valid_ether_addr(enetaddr))
return -1;
- return eth_setenv_enetaddr("ethaddr", enetaddr);
+ return eth_setenv_enetaddr(env_var, enetaddr);
}
+#define SB_FX6_I2C_EEPROM_BUS 0
+#define NO_MAC_ADDR "No MAC address found for %s\n"
int board_eth_init(bd_t *bis)
{
int err;
- err = handle_mac_address();
- if (err)
- puts("No MAC address found\n");
+ if (handle_mac_address("ethaddr", CONFIG_SYS_I2C_EEPROM_BUS))
+ printf(NO_MAC_ADDR, "primary NIC");
+
+ if (handle_mac_address("eth1addr", SB_FX6_I2C_EEPROM_BUS))
+ printf(NO_MAC_ADDR, "secondary NIC");
SETUP_IOMUX_PADS(enet_pads);
/* phy reset */
@@ -469,6 +473,11 @@ int ft_board_setup(void *blob, bd_t *bd)
"local-mac-address", enetaddr, 6, 1);
}
+ if (eth_getenv_enetaddr("eth1addr", enetaddr)) {
+ fdt_find_and_setprop(blob, "/eth@pcie", "local-mac-address",
+ enetaddr, 6, 1);
+ }
+
return 0;
}
#endif
--
1.9.1
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
