Hi Simon, On Thu, Jan 22, 2015 at 11:42 AM, Simon Glass <[email protected]> wrote: > Hi Bin, > > In the Baytrail FSP docs I see a note about the HOB passing back the > 'Boot Loader Temporary Memory Data HOB'. This seems to be a copy of > the entire temporary memory space. I wonder if we could recover struct > global_data from this? >
Yes, I think so. And I have verified this temporary memory space indeed contains stack contents before fsp_init() from U-Boot shell on Crown Bay. But the overall process might be complicated. See below. > If so, then we could move the fsp_init stuff to dram_init(), perhaps? > > But perhaps this is a feature of only this FSP? > I believe this is a feature defined by the FSP architecture spec, so every FSP should support that. Technically it should be no problem to call fsp_init() from arch_cpu_init() or even later dram_init(). However, I would say doing so brings us more harm than good. The following points are what I thought about before: 1). fsp_init() takes one parameter 'stack_top' to setup another stack after DRAM is initialized. This means everything on the previous CAR stack will need to migrate to the new stack below 'stack_top'. This includes global data, early malloc pointers, arch_cpu_init() stack variables and its return address. 2). Copy previous global_data to the new places under stack_top, and fix up gd->arch.gd_addr. 3). The initf_malloc() is called before arch_cpu_init() so we need fix up the early malloc pointers manually (gd->malloc_base and gd->malloc_limit) 4). Fix up the stack variables and return address of arch_cpu_init() on the new stack. 5). On Tunnel Creek, if we call setup_gdt() in start.S, later fsp_init() in arch_cpu_init() will fail to bring up the thread 1 (Tunnel Creek supports SMT), the reason of which is unknown to me yet (FSP is a black box). It looks to me that FSP is assuming GDT only contains two entries (32-bit 4G flat address) before calling fsp_init(). I have not looked into this any further, so the above points might not be 100% right. I would say with these modifications, the codes are more difficult to understand. Regards, Bin _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
