On 27.01.2015 15:22, Tom Rini wrote:
We had the problem on an AM33xx platform, that SPL detected an
unsupported boot-device. But since this message is a debug message
it took a bit of time to really know, where the hangup in SPL
resulted from. So let's change this debug message to a printf
and also print the detected boot-device that is not supported.
This makes debugging of such cases much easier.
Signed-off-by: Stefan Roese <[email protected]>
Cc: Wolfgang Denk <[email protected]>
Cc: Tom Rini <[email protected]>
Acked-by: Heiko Schocher <[email protected]>
Applied to u-boot/master, thanks!
This patch is causing problem on Microblaze because SPL exceed 4k limit.
It is only one printf which is called in entire SPL that's why this should
be solved a little bit differently.
OK, but for clarity you need and are using both
CONFIG_SPL_SERIAL_SUPPORT and CONFIG_SPL_LIBCOMMON_SUPPORT because
you're using puts but not printf, yes?
Right. If this is the case (only puts usage on Microblaze), then its
perhaps best that I change this line to puts as well. Okay?
Thanks,
Stefan
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
