Only set the speed if it has changed from last time. Since the speed will be 0 when the device is probed it will always be changed on the first transfer after the device is probed.
Signed-off-by: Simon Glass <[email protected]> --- drivers/spi/spi-uclass.c | 9 ++++++--- include/spi.h | 3 +++ 2 files changed, 9 insertions(+), 3 deletions(-) diff --git a/drivers/spi/spi-uclass.c b/drivers/spi/spi-uclass.c index 63a6217..34cab34 100644 --- a/drivers/spi/spi-uclass.c +++ b/drivers/spi/spi-uclass.c @@ -63,9 +63,12 @@ int spi_claim_bus(struct spi_slave *slave) } if (!speed) speed = 100000; - ret = spi_set_speed_mode(bus, speed, slave->mode); - if (ret) - return ret; + if (speed != slave->speed) { + ret = spi_set_speed_mode(bus, speed, slave->mode); + if (ret) + return ret; + slave->speed = speed; + } return ops->claim_bus ? ops->claim_bus(bus) : 0; } diff --git a/include/spi.h b/include/spi.h index c58e453..0d9ae97 100644 --- a/include/spi.h +++ b/include/spi.h @@ -99,6 +99,8 @@ struct dm_spi_slave_platdata { * @dev: SPI slave device * @max_hz: Maximum speed for this slave * @mode: SPI mode to use for this slave (see SPI mode flags) + * @speed: Current bus speed. This is 0 until the bus is first + * claimed. * @bus: ID of the bus that the slave is attached to. For * driver model this is the sequence number of the SPI * bus (bus->seq) so does not need to be stored @@ -116,6 +118,7 @@ struct spi_slave { #ifdef CONFIG_DM_SPI struct udevice *dev; /* struct spi_slave is dev->parentdata */ uint max_hz; + uint speed; uint mode; #else unsigned int bus; -- 2.2.0.rc0.207.ga3a616c _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
