Hello Simon,
Am 24.02.2015 14:31, schrieb Simon Glass:
Hi Heiko,
On 23 February 2015 at 23:18, Heiko Schocher <[email protected]> wrote:
a6b541b090: TI ARMv7: Don't use GD before crt0.S has set it
moves the init of the debug uart at the very end of SPL code.
Enable it for the siemens board earlier, as they print
ddr settings ... all debug output before board_init_r()
is here currently useless. Maybe we must rework this
globally?
Assuming we are talking about U-Boot proper, the DDR init should
happen in board_init_f(), specifically dram_init(). so I think this
code should be updated.
If it is SPL, then DDR init should happen in SPL's board_init_f().
It is in SPL...
sdram_init() is called from:
./arch/arm/cpu/armv7/am33xx/board.c from s_init() ...
I sent a series a few weeks ago (available at u-boot-dm branch
spl-working) related to this topic:
http://patchwork.ozlabs.org/patch/438581/
Ah ... Hmm... so "./arch/arm/cpu/armv7/am33xx/board.c" needs
a rework, right?
Is a simple rename s_init() -> board_init_f() correct?
@Tom: Could you help here?
bye,
Heiko
Signed-off-by: Heiko Schocher <[email protected]>
---
board/siemens/common/board.c | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/board/siemens/common/board.c b/board/siemens/common/board.c
index cc0ac6b..fb2de48 100644
--- a/board/siemens/common/board.c
+++ b/board/siemens/common/board.c
@@ -43,6 +43,11 @@ void set_mux_conf_regs(void)
/* Initalize the board header */
enable_i2c0_pin_mux();
i2c_set_bus_num(0);
+
+ /* enable early the console */
+ gd->baudrate = CONFIG_BAUDRATE;
+ serial_init();
+ gd->have_console = 1;
if (read_eeprom() < 0)
puts("Could not get board ID.\n");
--
2.1.0
Regards,
Simon
--
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
