Hi Tom, On 21-04-15 16:03, Tom Rini wrote:
Hey,I've run into a problem with ethernet on the A20 Lime2: sunxi# setenv autoload no sunxi# dhcp Speed: 1000, full duplex BOOTP broadcast 1 DHCP client bound to address 192.168.0.185 (13 ms) sunxi# tftp test/u-boot-sunxi-with-spl.bin Speed: 1000, full duplex Using dwmac.1c50000 device TFTP from server 192.168.0.3; our IP address is 192.168.0.185 Filename 'test/u-boot-sunxi-with-spl.bin'. Load address: 0x42000000 Loading: ################################################################# ######### 23.4 KiB/s done Bytes transferred = 377028 (5c0c4 hex) sunxi# crc32 $fileaddr $filesize CRC32 for 42000000 ... 4205c0c3 ==> afa0edfb $ rhash -C /tftpboot/test/u-boot-sunxi-with-spl.bin ; Generated by RHash v1.2.8 on 2015-04-21 at 10:01.53 ; Written by Aleksey (Akademgorodok) - http://rhash.sourceforge.net/ ; ; 377028 09:52.08 2015-04-21 /tftpboot/test/u-boot-sunxi-with-spl.bin /tftpboot/test/u-boot-sunxi-with-spl.bin A16F5564 So a non-crc32 match. If I load that same file off of SD card: sunxi# mmc read 43000000 10 400 MMC read: dev # 0, block # 16, count 1024 ... 1024 blocks read: OK sunxi# cmp 42000000 43000000 $filesize word at 0x42001544 (0x605a0200) != word at 0x43001544 (0x605a0201) Total of 1361 word(s) were the same I haven't had a chance to bisect this but it might have been around for a little while.
Chances are this has never worked 100% reliable, on most boards some tweaking of the GMAC clk delays is necessary. Try setting CONFIG_GMAC_TX_DELAY=1 In the defconfig for your board, that helps with similar issues on the Cubietruck (which also has gbit ethernet) Valid values are 0 - 3. Regards, Hans _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
