---------- Forwarded message ----------
From: Konstantin Lezhnyev <[email protected]>
Date: 2015-05-26 13:30 GMT+05:00
Subject: Re: [U-Boot] Marvell Armada XP u-boot from uart
To: Stefan Roese <[email protected]>
I'm sorry, the wording of my question was too short.
I have already fulfilled the steps described in the article.
But the article describes loading of the image from manufacturer - it is not
my case.
1. I create a configuration for my board from maxbcm config.
2. Set `BOOT_FROM` parameter in board\my\kwbimage.cfg to `uart`.
3. Set DDR timings/settings.
4. Upload and execute image via uart.
5. Memory training ended successfully.
But then I get the following messages in the terminal:
| >>spl:board_init_r()
| boot device - 8
| ...
| SPI probe failed.
Boot device 8 - constant `BOOT_DEVICE_SPI`.
Function code returns this value looks like:
| u32 spl_boot_device(void)
| {
| /* Right now only booting via SPI NOR flash is supported */
| return BOOT_DEVICE_SPI;
| }
And now I repeat my question:
>Is it possible to load and boot Marvell Armada XP u-boot completely from
uart without spi or nand flash?
Regards,
kon5t.
2015-05-23 13:08 GMT+05:00 Stefan Roese <[email protected]>:
> On 22.05.2015 16:12, Peter Robinson wrote:
>
>> Is it possible to load and boot Marvell Armada XP u-boot completely from
>>> uart without spi or nand flash?
>>> I have custom board with MV78460 and clean flash memory.
>>>
>>
>> You can use kwboot I believe.
>>
>
> Correct. kwboot can be used to upload and execute a binary (compiled for
> UART booting) via UART. Please make sure to use the "-a" parameter for the
> Armada XP timings.
>
> Thanks,
> Stefan
>
>
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
