Hi Paul, On Sun, Jun 07, 2015 at 03:12:41PM +0200, Paul Kocialkowski wrote: > Hi, > > > Ethernet device initialization fails with the following message: > > Net: PH: dir_output: error: gpio PH23 not reserved > > Phy 1 not found > > PHY reset timed out > > eth0: ethernet@01c50000 > > > > Tested on Banana Pi board. > > > > Signed-off-by: Maxin B. John <maxin.j...@enea.com> > > --- > > arch/arm/cpu/armv7/sunxi/board.c | 1 + > > 1 file changed, 1 insertion(+) > > > > diff --git a/arch/arm/cpu/armv7/sunxi/board.c > > b/arch/arm/cpu/armv7/sunxi/board.c > > index a82c8b9..030a711 100644 > > --- a/arch/arm/cpu/armv7/sunxi/board.c > > +++ b/arch/arm/cpu/armv7/sunxi/board.c > > @@ -223,6 +223,7 @@ int cpu_eth_init(bd_t *bis) > > __maybe_unused int rc; > > > > #ifdef CONFIG_MACPWR > > + gpio_request(CONFIG_MACPWR, "MAC Power"); > > I suggest using the string "macpwr" instead to be consistent with: > board/sunxi/ahci.c: gpio_request(CONFIG_SATAPWR, "satapwr"); > > Good find otherwise!
Thanks for the comments. Will send a v2 soon. > > gpio_direction_output(CONFIG_MACPWR, 1); > > mdelay(200); > > #endif Best Regards, Maxin _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot