On Thursday, July 30, 2015 at 04:13:14 PM, LEMIEUX, SYLVAIN wrote: > Hi Marek,
Hi! > Thanks for the feedback. I will do the change and submit a new revision of > the patch. > > For your question regarding reference to UART 5 inside the USB driver; > * It is possible to also route the UART5 Tx/Rx pin to the USB D+ and D- > pins; the driver ensure this is not selected. > For details, refer to UM10326, "LPC32x0 and LPC32x0/01 User manual - > Rev. 3" table 459 and paragraph 17.2.3.2.6. > * I will add comments in the code. Well in that case, you should pull out a separate pinmux code and do the pinmuxing in the board setup code, definitelly not in the USB driver. Best regards, Marek Vasut _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
