On Monday, August 10, 2015 at 04:00:47 PM, Simon Glass wrote: > Hi Marek,
Hi Simon, > On 10 August 2015 at 07:57, Marek Vasut <[email protected]> wrote: > > On Monday, August 10, 2015 at 03:39:33 PM, Simon Glass wrote: > >> Hi Marek, > > > > Hi Simon, > > > >> On 2 August 2015 at 17:52, Simon Glass <[email protected]> wrote: > >> > On 2 August 2015 at 17:15, Marek Vasut <[email protected]> wrote: > >> >> Add Kconfig entries for the simple-bus driver, both for U-Boot > >> >> and for SPL. The simple-bus is enabled by default in U-Boot and > >> >> disabled by default in SPL to preserve the original behavior. > >> >> > >> >> Signed-off-by: Marek Vasut <[email protected]> > >> >> Cc: Simon Glass <[email protected]> > >> >> --- > >> >> > >> >> drivers/core/Kconfig | 15 +++++++++++++++ > >> >> drivers/core/Makefile | 5 ++--- > >> >> 2 files changed, 17 insertions(+), 3 deletions(-) > >> > > >> > Acked-by: Simon Glass <[email protected]> > >> > >> I can't apply this right now as it breaks most tegra boards. We use a > >> hack at present where we #undef things in config_uncmd_spl.h and that > >> isn't visible to the Makefiles. > >> > >> Assuming that Tom applies Masahiro's Kconfig improvements for SPL we > >> can do it then. > > > > Agh, OK, thanks for the heads up. > > > > I hope this makes it into 2015.10, otherwise the SPL support for SoCFPGA > > will be completely useless. > > One way or another we'll figure this out sooner rather than later. I know :) Best regards, Marek Vasut _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
