On Thursday, September 03, 2015 at 08:44:00 PM, Moritz Fischer wrote: > Hi all,
Hi! > this patch adds basic support for NI Ettus Research E3XX series > boards. I tagged this RFC because I'm not sure if the boards/xilinx/zynq > subdirectory is the correct place for this, as I'll have some follow up > patches that read the devices EEPROM for ethernet address etc. It's not, it should be board/ettus/e3xx/ . > Would putting it under boards/ni/zynq be the correct way of integrating it? > While technically a Zynq device there are a lot of custom modifications, > that I wouldn't like to force into board/xilinx/zynq/board.c in my follow > up patches. However duplicating the entire board.c doesn't seem like a > good idea neither. > > Any suggestions? For future reference do you want me to split out dts etc > in a separate patch? It's always boards/VENDOR/BOARD/ . Best regards, Marek Vasut _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
