Hello Jaehoon,
On 09/25/2015 04:40 AM, Jaehoon Chung wrote:
Hi, Przemyslaw.
On 09/25/2015 12:29 AM, Przemyslaw Marczak wrote:
Booting of Odroid U3 with SD card, ends with error:
MMC: EXYNOS DWMMC: 0
Card did not respond to voltage select!
*** Warning - MMC init failed, using default environment
Generally this was broken, because of wrong addresses assigned to GPIOs.
Great! I will check this patch-set..But it seems to look good to me. :)
Best Regards,
Jaehoon Chung
At present, the patchset was tested on U3/X2 and XU3.
The source of the problem was in rework of lib/fdtdec.c, after which
function fdtdec_get_addr() doesn't work as previous and function
dev_get_addr() doesn't works as expected.
The code after rework in lib/fdtdec.c assume, that #size-cells property,
should be always greater or equal to 1. This was wrong, because it can be 0.
In case of debugging the issue I found, that mmc clock was computed wrong,
for Exynos4, because of function get_mmc_clk(), which always return -1 for
this SoC.
Tested on: Odroid U3 and Odroid XU3.
Przemyslaw Marczak (3):
fix: fdtdec: allow parse 'reg' property with zero value in
'#size-cells'
fix: s5p_gpio: call: dev_get_addr() instead of fdtdec_get_addr()
fix: mach-exynos: clock: restore calling dead exynos4_get_mmc_clk()
arch/arm/mach-exynos/clock.c | 10 ++++------
drivers/gpio/s5p_gpio.c | 18 +++++++++++-------
lib/fdtdec.c | 2 +-
3 files changed, 16 insertions(+), 14 deletions(-)
Best regards,
--
Przemyslaw Marczak
Samsung R&D Institute Poland
Samsung Electronics
[email protected]
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
