On Wed, Jul 29, 2009 at 10:05:45PM +0530, Rupesh Kumar wrote: > I am using u-boot version 1.3.0 included in freescale LTIB released for > MPC8313ERDB custom board. > I tried NAND booting of MPC8313ERDB board using this u-boot and it worked > fine. > > Using similar procedure i tried NAND boot on my custom board but it dint > work :( > > My board has large page NAND where as MPC8313ERDB has small page NAND. I > have modified all the parameters required for Large page NAND. > It prints initail debug message as shown below and then while copying > u-boot code from NAND to DDR it detects NAND blocks as bad block and > continuously prints 'B' on Console. > > NAND SPL - U-Boot 1.3.0 (Jul 30 2009 - 06:33:05) MPC83XX > Loading from NAND : > BBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBB > BBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBB > > > Can any one please tell what could be going wrong? Am i missing something > in large page NAND initialization?
Please try the current upstream u-boot rather than the BSP version. Large page support in the mpc8313erdb BSP is likely broken. -Scott _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot