Hi, All.
On 10/05/2015 08:47 PM, Tobias Jakobi wrote:
> Add more debug printfs in do_sdhci_init() for calls
> that can potentially fail.
>
> Acked-by: Przemyslaw Marczak <[email protected]>
> Signed-off-by: Tobias Jakobi <[email protected]>
> ---
> drivers/mmc/s5p_sdhci.c | 20 +++++++++++---------
> 1 file changed, 11 insertions(+), 9 deletions(-)
>
> diff --git a/drivers/mmc/s5p_sdhci.c b/drivers/mmc/s5p_sdhci.c
> index b203bee..15ecfee 100644
> --- a/drivers/mmc/s5p_sdhci.c
> +++ b/drivers/mmc/s5p_sdhci.c
> @@ -101,29 +101,31 @@ struct sdhci_host sdhci_host[SDHCI_MAX_HOSTS];
>
> static int do_sdhci_init(struct sdhci_host *host)
> {
> - int dev_id, flag;
> - int err = 0;
> + int dev_id, flag, ret;
>
> flag = host->bus_width == 8 ? PINMUX_FLAG_8BIT_MODE : PINMUX_FLAG_NONE;
> dev_id = host->index + PERIPH_ID_SDMMC0;
>
> if (dm_gpio_is_valid(&host->pwr_gpio)) {
> dm_gpio_set_value(&host->pwr_gpio, 1);
> - err = exynos_pinmux_config(dev_id, flag);
> - if (err) {
> + ret = exynos_pinmux_config(dev_id, flag);
> + if (ret) {
> debug("MMC not configured\n");
> - return err;
> + return ret;
> }
> }
>
> if (dm_gpio_is_valid(&host->cd_gpio)) {
> - if (dm_gpio_get_value(&host->cd_gpio))
> + ret = dm_gpio_get_value(&host->cd_gpio);
> + if (ret) {
> + debug("no SD card detected (%d)\n", ret);
> return -ENODEV;
> + }
This patch was already applied. But i didn't know why used "ret" at here.
If cd-gpio is active-high, this should be always returned "no SD card detected".
Even if commonly cd-gpio is active-low, we don't know whether cd-gpio is
active-low or not.
And dm_gpio_get_value() should be returned error for only one case.
Best Regards,
Jaehoon Chung
>
> - err = exynos_pinmux_config(dev_id, flag);
> - if (err) {
> + ret = exynos_pinmux_config(dev_id, flag);
> + if (ret) {
> printf("external SD not configured\n");
> - return err;
> + return ret;
> }
> }
>
>
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
