On Thursday, December 17, 2015 at 05:15:46 PM, Tim Harvey wrote: > On Thu, Dec 17, 2015 at 7:40 AM, Marek Vasut <ma...@denx.de> wrote: > > On Thursday, December 17, 2015 at 04:36:20 PM, Tim Harvey wrote: > >> On Wed, Dec 16, 2015 at 6:40 AM, Marek Vasut <ma...@denx.de> wrote: > >> > Add DDR3 calibration code for i.MX6Q, i.MX6D and i.MX6DL. This code > >> > fine-tunes the behavior of the MMDC controller in order to improve > >> > the signal integrity and memory stability. > >> > > >> > Signed-off-by: Marek Vasut <ma...@denx.de> > >> > Cc: Stefano Babic <sba...@denx.de> > >> > >> Marek, > >> > >> This is great - this would be a great addition to U-Boot IMX6 SPL. > >> > >> You must have forgotten to post a dependent patch that adds some of > >> the registers to mmdc_p_regs. If you can post that I can run this > >> through some testing. > > > > What exactly is missing please ? I am using this on Novena for a while > > without issues. > > sorry my bad... forgot I was on an old branch. All is good. > > I will run some boards with this through some stress testing and review.
Whew! OKi, thanks! Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
