On 01/11/2016 04:21 AM, Przemyslaw Marczak wrote:
Hello Stephen,
On 01/07/2016 07:25 PM, Stephen Warren wrote:
On 01/07/2016 04:40 AM, Przemyslaw Marczak wrote:
The present implementation of __of_translate_address() taken
from the Linux, is designed for translate bus/child address
mappings by using 'ranges' property - and it doesn't allow
for checking an address for a device's node with zero size-cells.
The 'size-cells > 0' is required for bus/child address mapping,
but is not required for non-memory mapped address, e.g.: I2C chip.
Then when we need only raw 'reg' property's value.
Since the I2C device address goes to a single-cell reg property,
support for that case is welcome, but currently calling dev_get_addr()
for I2C device will return 'FDT_ADDR_T_NONE', and print the warning:
warning:
__of_translate_address: Bad cell count for 'some-dev'
This patch takes the wrong approach.
It simply doesn't make sense to /attempt/ to translate an I2C address
into an MMIO address space. It's a nonsensical operation; no such
translation is possible under any circumstances because I2C and MMIO
addresses mean completely different things and simply can't be
translated to each-other.
Rather than making this nonsensical operation succeed in a way that
gives the desired no-op result, the nonsensical operation simply
shouldn't be performed in the first place.
Okay, the example with I2C may be little confusing - I could use some
general naming convention. However, this patch updates FDT-related code
only.
In one of your previous e-mails, you well argued that we shouldn't use
dev_get_reg() for some buses, since they have a different 'reg' meaning.
You are right, using dev_get_addr() as universal function may be
nonsensical.
Please note, that the present implementation of function:
'__of_translate_address()' - allows for 1:1 translation, but only if
'#size-cells' exists. So the below case is possible:
----------------------
parent {
address-cells = <1>;
size-cells = <1>;
reg = <0x10000000 0x1000>;
child {
reg = <0xa00 0x100>;
};
};
dev_get_reg(child) - will return '0xa00'
----------------------
If we don't need the address length, we can define:
----------------------
parent {
address-cells = <1>;
size-cells = <0>;
reg = <0x10000000 0x1000>;
child {
reg = <0xa00>;
};
};
This case won't ever appear in a correctly written DT where reg
represents an MMIO address; MMIO addresses always have sizes, and hence
can't have size-cells=0. Hence, translating through a DT structures like
that is an error case, and shouldn't work.
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
