Hi Joe, On Tue, 2016-01-19 at 07:02 +0000, Alexey Brodkin wrote: > Hi Joe, > > On Wed, 2016-01-13 at 16:59 +0300, Alexey Brodkin wrote: > > In some cases Ethernet PHY and network itself might support speeds > > which are not supported by Ethernet controller (MAC). > > > > To support that kind of situation it is required to force limit > > PHY so it is not configured for unsupported mode or even if PHY > > autonegotiated too high speed it will be reconfigured for slower mode. > > > > Note this series is v2 because v1 patches were sent separately not being > > aranged in series. And now I'm putting all patches in one series > > and marking it v2 even though no changes were done in patches itself. > > > > Alexey Brodkin (4): > > drivers/net/phy: introduce phy_set_supported() > > include/net.h: add max_speed member in struct eth_pdata > > net/designware: do explicit port selection for 1Gb mode > > net/designware: add support of max-speed device tree property > > > > Florian Fainelli (2): > > net: phy: ensure Gigabit features are masked off if requested > > net: phy: breakdown PHY_*_FEATURES defines > > > > Sascha Hauer (1): > > net: phy: genphy: Allow overwriting features > > > > drivers/net/designware.c | 16 +++++++++- > > drivers/net/designware.h | 1 + > > drivers/net/phy/phy.c | 77 > > ++++++++++++++++++++++++++++++++++-------------- > > include/net.h | 2 ++ > > include/phy.h | 23 ++++++++++----- > > 5 files changed, 89 insertions(+), 30 deletions(-) > > Please treat this as a polite reminder to review > that series sometime soon.
Thank you for reviewing that series. I'm wondering who's going to pick it up? -Alexey _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
